Main - Tactics - Fiction - Rumours - Army Features
Editorials - Tournaments - Modelling - Trial Rules
Forums - Submissions - Site Map - Links - Contact Me

Sculpting Techniques: Laurels - Khorne's Rage

This is a guide I'd written for Tinfish. We were talking one day and he montioned that he'd like to try to put laurels onto his Deciever but didn't know how.
Not having anythign better to do, I gave it a go...

Firstly, find something flat that you can move about & dont mind putting Greenstuff onto (i'm using the plastic insert the Balrog comes in, but a blister pack would suffice).

Next, apply some moisture to the top of the pack.
I use water dapped from a damp sponge, but some people use oils.
The purpose is to stop the greenstuff sticking to the pack. This takes a bit of practise, several times i had to start again as the greenstuff had stuck to the pack...
Place a piece of greenstuff about the right size for the laurel on the pack.
Use a modelling tool to even out the thickness and smoothen out any fingerprints.

Once you have an even height of greenstuff, use a fine knife to cut off the edges to get an even rectangle.


After cutting each edge, use the flat of the blade to make sure the Greenstuff hasn't stuck to the packet.

After getting a nice clean, even shape, take a sharp modelling knife & score a line down the centre of the greenstuff gently.
Then check the Greenstuff is still moveable & not stuck to the work surface :)

Now Very Very Carefully, cut the corners off the end at about 45 degrees.

Now run slightly deeper marks at 45degree angle all along both sides of teh line.
Take your time & try to get the lines even :) They need to be deep enough that they are not obscured by the undercoat, but not actually cutting all the way through the greenstuff.


then check the Greenstuff is still moveable.. spot a pattern here?

Next, mark & cut off a triangle along the other end, try to keep it central!
then check the Greenstuff is still moveable...

Finally, leave for an hour or so for the greenstuff to start to start to harden (but still flexible enough to place on the fig!) .
Carefully peel it off the pack and position on the figure. It's generally best to place the pointed end, then wrap the laurel around, then cut off any excess on the other end.

Repeat all these steps for the otherside, leave to dry overnight

This takes alot of practice to get right (from not sticking the laurel to the lid to liting it without tearing it...) , but it certainly worth the effort!

Rage

Want to discuss this? Or anything else?

Click here, and talk to us on the forums

Main - Tactics - Fiction - Rumours - Army Features
Editorials - Tournaments - Modelling - Trial Rules
Forums - Submissions - Site Map - Links - Contact Me